Step 1
Install NSP to your workstation.
Download the setup file and run the file on the your (admin) workstation. Go through the installer and click "Allow" or "Unblock" on any firewall messages that appear after installing. Once you are inside the Admin Control Panel, proceed to the next step.

Step 2
Install the setup file to other workstations you wish to monitor.
Install the same setup file to a few test workstations. Verify that the NSP Status is Active. Then click X to exit the interface. The server will remain running. Be sure to click "Allow" or "Unblock" on any firewall messages that appear after installing.

Step 3
Connect to a workstation from your workstation.
To start, click "View Logs". Then click Refresh All. Your networked PC's should appear in the list. If nothing appears you can use the "Network Scan" to scan for systems. From either screen, click a system to select it. Then click "View Activities".

A browser screen will appear asking for the password. By default the password is "retinax". After you are logged in, click any of the commands on the left side to utilize the software on the PC you are connected to.

Step 4
Try the new "Real-time View" features of NSP.
From your Admin Control Panel, click "Real-time View". Then click Add to add some workstations to the Real-time list. Then click "Start Session" to view what task each user's PC is currently on.

Don't miss the "View Screens" command. A browser screen will appear with real time screen images of each workstation in the list.